top of page

6 STEPS THE PROS USE TO HOT GLUE DENTS OUT 💪

[yes, this is real I’ve been doing this professionally since 2005]


-links at bottom


1. Prep it Right

Clean the panel and Tab with 91% isopropyl alcohol

Make sure the panel is not HOT or COLD to the touch


2.APPLY GLUE TO TAB

Make sure you’re using professional PDR hot glue. This glue is called Tequila Fire from Anson PDR


3.Allow Glue time to SET

(This takes different timeframes depending on the glue and conditions) (if you’re a rookie experiment with different times)


4.PULL THE DENT

(In this video I used what’s called a PDR SLIDE HAMMER. But you can use other tools like MINI LIFTERS or Keco K-bar tool)


5. Remove the Tab

Use 91% isopropyl alcohol to release the adhesion from the panel and the tab


6.Knock down what’s High

If you pulled the dent up too far, knock it down with what we call a hammer and “knock down”


7.REPEAT UNTIL FINISHED.


Links to tools (some are affiliate links👍)


glue gun https://amzn.to/440Cg2C

hot glue https://amzn.to/3Omg8tX

91% alcohol https://amzn.to/3KuuUNX

slide hammer https://www.pdrtool.com/products/standard-slide-hammer-made-in-usa?_pos=3&_sid=5eba2270c&_ss=r

Knock down https://www.pdrtool.com/products/scepter-knockdown-kit?_pos=1&_sid=946113c20&_ss=r


5 views0 comments

Recent Posts

See All
bottom of page